: After cooking, use the Delay Off feature (often 10 minutes) to ensure all residual odors and grease particles are fully extracted. 3. Maintenance and Cleaning
This article breaks down everything you need to know about the TGC BC-90-1H, from technical specifications to routine maintenance. 1. Introduction to the TGC BC-90-1H
If you need a physical manual (for a workshop or OSHA compliance), check: tgc bc-90-1h manual
While the controller is active, use the arrow buttons or the temperature button to set your desired temperature (typically ranging from 35°C up to 48°C or higher depending on the model setting). The system will remember this setting for the next use. 3. Taking Priority Control (Priority Button)
Press the Priority Button on your BC-90-1H. Its priority indicator light will turn on, and other controllers will flash or turn off. : After cooking, use the Delay Off feature
Your TGC water heater can be connected to a maximum of:
: If left in standby mode for over 10 minutes at a high temperature (50°C+), the unit automatically scales back down to 48°C to prevent the next user from getting burned. ⚠️ Safety Parameters and Built-in Protections check: While the controller is active
A slight backward tilt (no more than 1 centimeter) helps the glass door close automatically and seal tightly. Operating instructions & Temperature Control