Cobra 3195 Alarm Manual Full Exclusive (Popular)

Proper installation requires knowledge of automotive electrical systems. Disconnect the vehicle battery before making connections. Main Harness Wiring Connections Wire Color Connection Point Chassis Ground Connect to a clean, unpainted factory ground bolt. Red +12V Permanent Power Connect to a fused constant 12V source (15A fuse). Orange +12V Ignition Sense

: If programmed, the system may arm itself automatically 30 seconds after the ignition is turned off and the last door is closed. Emergency Disarming (PIN Code)

The turn indicators will flash, and the LED will begin flashing to show the alarm is active. If the buzzer is enabled, it will beep twice to confirm. Disarming the Alarm Press the on the remote transmitter. The indicators will flash, and the LED will turn off. Disarming with Personal PIN Code (Emergency) If you lose your remote or the battery fails: Open the door with the mechanical key (alarm will sound). Turn the ignition key ON . cobra 3195 alarm manual full

Enter your 4-digit PIN code using the ignition/LED method outlined in Section 3.

: Press the "Unlock" button on your vehicle's original remote. The hazard lights will flash twice, and the LED will stop flashing. Passive Arming Red +12V Permanent Power Connect to a fused

Replace remote battery (CR2032). Then re-learn remote (Section 3.2). Also ensure the alarm’s antenna wire (thin black wire) is not coiled or cut – extend it straight up behind the dashboard.

A: The standard remote key fob for this system uses a CR2032 lithium battery. If the buzzer is enabled, it will beep twice to confirm

: To arm the system while leaving windows slightly open or a pet inside, arm the system normally and then press Button B twice within 20 seconds to disable the internal motion sensors for that cycle. Programming & Resynchronization

Turn the ignition ON and OFF 3 times within 7 seconds . The dashboard security LED will light for 3 seconds. Enter PIN: Immediately after the LED goes out, turn the ignition ON .

The 3195 can be programmed for specific vehicle features using the override button. Changing the PIN Code (Override) Disarm the system. Turn ignition ON. Press the button for 5 seconds until the LED flashes.