Turn to change values. Press the knob to move the cursor (jump from 0.1V to 1V increments).
To enter the protection menu, (approx. 2 seconds) while on any main screen. Use SW to cycle through these parameters: LVP: Low Voltage Protection (Input undervoltage). OVP: Over Voltage Protection (Output overvoltage). OCP: Over Current Protection. OPP: Over Power Protection. OHP: Overtime Protection (auto-off after set time). OAP: Over-capacity Protection (auto-off after set Ah). Key Technical Specifications Range/Value Input Voltage 6.0V – 36V Output Voltage 0.6V – 36V Output Current 0 – 5.0A Output Power 80W Max (requires cooling for sustained high loads) Safety Features Input anti-reverse, Output anti-backflow, OTP (Over-temp)
: Allows for direct battery charging without needing an external diode. Adjustable Thresholds Zk-5kx Manual
is a high-performance, digitally controlled DC-DC buck-boost converter designed for versatility in electronic projects. Operating from a and providing 0.6V–36V output , this 5A module (max) excels at regulating power, charging batteries, and driving LEDs. This manual covers installation, operation, features, and settings for the ZK-5KX converter. 1. Product Overview and Technical Specifications
, making it suitable for demanding applications like motor control or high-power LED arrays. CC/CV Regulation Turn to change values
: Attach your primary DC source (such as a laptop power brick, battery pack, or fixed switching power supply) to the IN+ and IN- terminals.
I can provide more troubleshooting tips for this module if needed. Let me know: What are you using for the input? What load or device are you trying to power or charge? 2 seconds) while on any main screen
: Use the constant current mode to safely power LEDs without a resistor.
Short press the button again to save the settings and exit back to the normal interface. (Alternatively, wait 6 seconds for the module to auto-save and exit). Configuring System Protection Thresholds
Usually indicates a protection trigger (OVP/OCP). Check your limits in the SET menu.