Xh-m608 Manual - !link!

Press the left button to increase the voltage or the right button to decrease it. Wait 3 seconds to save. 4. Operational Modes (Use Case Examples) Mode 1: Charging Control (Overcharge Protection) Charge a 12V lead-acid battery and stop when full. Setup: U₁ (lower) = 12V, U₂ (upper) = 14.4V.

The XH-M608 features a straightforward design, with input, battery, and relay connections clearly marked on the circuit board. Input Power ( VINcap V sub cap I cap N end-sub VINcap V sub cap I cap N end-sub Xh-m608 Manual

The relay acts as an open-close switch, interrupting the connection between the battery and the charger or the load. 3. Programming and Settings Press the left button to increase the voltage

Think of it as a weakling whispering orders to a bodyguard. The microcontroller whispers “On” – the relay’s electromagnetic coil clunks – and suddenly, high-voltage power flows. Operational Modes (Use Case Examples) Mode 1: Charging

What is the of your battery bank (12V, 24V, 48V)? Are you using this for charging or discharging ?

The battery voltage is below 6V, or the wiring polarities are reversed.

: This acts as a switch. It does not output voltage; it just completes or breaks a circuit for your charger or your load. 2. Button Functions