USB (Type-B or Type-C) & 8-Pin Offline Controller port.
Connects the board to your computer for sending G-code.
Ultimate Guide to Annoy Tools CNC Control Boards: Wiring, Setup, and Troubleshooting annoy tools cnc board manual pdf
If you need help setting up a specific machine model, tell me:
Annoy Tools boards run on standard open-source GRBL firmware. You do not need proprietary tools to control your machine. Recommended Control Software USB (Type-B or Type-C) & 8-Pin Offline Controller port
The Annoy Tools board is plug-and-play with most open-source CNC software.
To control the Annoy Tools board, you need control software and the correct USB drivers. Driver Installation Most Annoy Tools boards use the . You do not need proprietary tools to control your machine
Installing the board typically takes less than an hour if following standard procedures.
To get the most out of your Annoy Tools CNC board manual PDF: