Daikin Brc1c51 61 Installation Manual

Strip approximately 6–7 mm of insulation from the ends of the two wires.

: Crucial information on connecting control wires between the indoor unit and the remote controller, with specific instructions to keep these at least 3.5 feet (1 meter) away from televisions or radios to prevent interference. Service & Diagnostic Modes

Install the controller on a flat surface, avoiding areas with high humidity, direct sunlight, or extreme electromagnetic radiation.

The Daikin BRC1C51/61 can be flush-mounted into a standard electrical switch box or mounted directly to a flat wall surface. Step-by-Step Mounting daikin brc1c51 61 installation manual

Route the other end of the wire to the indoor unit electrical box. Connect them to the corresponding and P2 terminals on the indoor unit terminal block. Dual Remote Controller Setup (Main vs Sub)

Hold the case level against the wall, mark the screw holes, insert wall anchors, and screw the case into place.

: The controller may be mounted in a drafty area or near a heat source. Modify Field Setting 10-2 to utilize the indoor unit's return air thermistor instead of the remote controller's sensor. If you need help configuring specific settings, tell me: What model of indoor unit is connected? Strip approximately 6–7 mm of insulation from the

Press the once to enter setting mode (the day will blink). Use the UP/DOWN buttons to select the day. Press RTC to confirm and move to the hour setting. Adjust the hours and minutes using the same method.

Peel off the protective seal from the screen only after installation is complete. 3. Post-Installation & Commissioning

Wire both controllers in parallel to the P1 and P2 terminals of the indoor unit. Alternatively, daisy-chain P1/P2 from the first controller to the second controller. The Daikin BRC1C51/61 can be flush-mounted into a

The setting is confirmed only after all steps are completed; otherwise, it will exit after 5 seconds of inactivity.

: Connect the control terminals P1 and P2 on the remote controller to the terminals P1 and P2 on the indoor unit.

: Keep control wires at least 3.5 feet (1 meter) away from televisions or radios to prevent signal interference. Use only copper wire and ensure all electrical work conforms to local codes.