-
ПАРТНЁРАМ
Партнерская программа хостинга newПартнерство по доменам
Check physical connections; verify port settings within Magellan device manager. Xenon lamp degradation or misaligned optics.
| Frequency | Task (from manual) | Manual Section | | :--- | :--- | :--- | | Daily | Wipe the plate carrier with lint-free cloth. Check for liquid spills under the carriage. | Section 6.2 | | Weekly | Run the “Optical Test” with the installed calibration plate. Verify OD < 0.01 at 450nm. | Section 9.1 | | Monthly | Clean the exterior vents with compressed air. Ensure the fan is unobstructed. | Section 12.3 | | Bi-annually | Perform a wavelength verification using holmium oxide filter (absorbance) or fluorescent standard (Rhodamine B). | Section 9.4 | | Annually | Replace the xenon flash lamp (if flash count > 8e8). The manual provides the lamp alignment jig instructions. | Section 12.7 |
⚠️ Avoid third-party PDF hosting sites — they may contain outdated or incorrect versions.
Schedule a preventative maintenance (PM) visit with a certified Tecan technician.
Connect the Safire 2 to the control computer using the manufacturer-specified interface cable (typically RS232 or USB-to-serial converter depending on the specific hardware revision). Operating Instructions via Magellan Software
Absorbance, Fluorescence Intensity (Top/Bottom), Time-Resolved Fluorescence (TRF), Luminescence Ambient + 4°C up to 42°C 3. Standard Operating Procedures (SOP) Initial Startup Sequence
For official documentation, including installation, operation, and maintenance manuals, users should rely on authorized channels. While specific PDF links can change, the following resources are the most reliable:
Check physical connections; verify port settings within Magellan device manager. Xenon lamp degradation or misaligned optics.
| Frequency | Task (from manual) | Manual Section | | :--- | :--- | :--- | | Daily | Wipe the plate carrier with lint-free cloth. Check for liquid spills under the carriage. | Section 6.2 | | Weekly | Run the “Optical Test” with the installed calibration plate. Verify OD < 0.01 at 450nm. | Section 9.1 | | Monthly | Clean the exterior vents with compressed air. Ensure the fan is unobstructed. | Section 12.3 | | Bi-annually | Perform a wavelength verification using holmium oxide filter (absorbance) or fluorescent standard (Rhodamine B). | Section 9.4 | | Annually | Replace the xenon flash lamp (if flash count > 8e8). The manual provides the lamp alignment jig instructions. | Section 12.7 | tecan safire 2 manual pdf
⚠️ Avoid third-party PDF hosting sites — they may contain outdated or incorrect versions. Check for liquid spills under the carriage
Schedule a preventative maintenance (PM) visit with a certified Tecan technician. | Section 9
Connect the Safire 2 to the control computer using the manufacturer-specified interface cable (typically RS232 or USB-to-serial converter depending on the specific hardware revision). Operating Instructions via Magellan Software
Absorbance, Fluorescence Intensity (Top/Bottom), Time-Resolved Fluorescence (TRF), Luminescence Ambient + 4°C up to 42°C 3. Standard Operating Procedures (SOP) Initial Startup Sequence
For official documentation, including installation, operation, and maintenance manuals, users should rely on authorized channels. While specific PDF links can change, the following resources are the most reliable:
