Ivoclar Programat P95 Manual
Check the O-ring on the firing plate. Verify pump oil level. Lift Malfunction Mechanical jam or faulty lift motor microswitch. Clean the lift guide rails. Lubricate if necessary. 6. Preventative Maintenance Schedule
It is recommended to perform a silver wire calibration test to ensure temperature accuracy before the first firing. 4. Operating Instructions Turning on the Unit
The temperature at which the vacuum pump activates.
A silver wire is used to check the calibration. The user determines if the temperature needs to be adjusted upwards or downwards based on the deformation of the wire. Ivoclar Programat P95 Manual
The buzzer will sound, and data will briefly appear on the display, followed by the active program values after approximately six seconds.
key to pre-set vacuum switch-on and switch-off points. Ensure the vacuum switch-off value does not exceed the set temperature to avoid error code Starting the Cycle: to open the furnace once it reaches at least 400 raised to the composed with power cap C
Allows the user to toggle through program numbers (typically programs 1 through 99). Check the O-ring on the firing plate
) is typically auto-programmed to 1 minute, and closing time ( ) to 30 seconds, though these can be manually adjusted. Vacuum Settings (
If a third-party pyrometer shows the P95 is firing too hot/cold, the operator can apply an offset (e.g., -5°C) without adjusting every program. Manual caution: Do not exceed ±10°C offset.
High-quality quartz tube heating element for even heat distribution. Clean the lift guide rails
Follow these steps for a standard dental ceramic firing cycle: Pre-Heating
Place the unit on a level, heat-resistant surface. Allow at least 10–15 cm of space around the unit for ventilation.
By following the guidelines and best practices outlined in this blog post and the Ivoclar Programat P95 manual, you'll be able to get the most out of your furnace and deliver exceptional results for your patients.
Plug the unit directly into a grounded wall outlet. Avoid using extension cords or sharing a circuit with high-draw equipment like casting machines.
Press the button. The furnace head will automatically descend according to the set closing time ( S ).
