Located on the back for alternative USB-C power input. Device Setup and Preparation
The is a powerful ally in managing your heart health, but it is only as good as the hand using it. By following this comprehensive guide—which mirrors and expands upon the official electronic blood pressure monitor X180 manual —you eliminate user error, understand error codes, and extend the life of your device.
A: Press and hold the MEM button for 5 seconds while in memory mode to delete all stored readings.
The cuff is the most important part of the measurement process. To connect it: electronic blood pressure monitor x180 manual
: Sit upright with your back supported and feet flat on the floor.
Press the MEM button while the device is off. It will first display the average of your last 3 readings. Press MEM again to cycle backward through individual stored measurements.
Look for the "Heart" icon; if it flashes during a reading, it may indicate an irregular heartbeat detection. Located on the back for alternative USB-C power input
Open the battery compartment on the bottom. Insert 4 AAA batteries matching the polarity (+/-) symbols.
Press the button to toggle between User 1 and User 2. Press SET to confirm.
Inaccurate readings are most often caused by improper cuff placement. Remove tight-fitting clothing from your upper left arm. A: Press and hold the MEM button for
: Systolic under 120 mmHg and Diastolic under 80 mmHg.
The X180 must be configured correctly to properly log your readings with accurate timestamps. Powering the Device The X180 operates via dual power sources:
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.