Carefully bend the small metal tang on the float to reach the correct height. Step 4: Reassembly
Unscrew the four Phillips screws. Be careful not to strip them, as they are often soft brass or zinc.
Start with the pilot screws at the factory-recommended setting (e.g., 2.5 turns out). mikuni bds26 service manual
This article serves as a comprehensive guide—a walkthrough—covering essential maintenance, tuning, and rebuilding techniques. 1. Understanding the Mikuni BDS26 Carburetor
A high-quality spray or a dip (like Berryman’s Chem-Dip). Carefully bend the small metal tang on the
Use a digital caliper to measure the distance from the gasket mating surface (without the gasket installed) to the highest point of the float profile.
Carefully tap the side of the bowl with a plastic mallet if it is stuck to the gasket. Do not pry with a screwdriver. Start with the pilot screws at the factory-recommended
Are you using or aftermarket modifications? Share public link
Would you like this reformatted as a printable PDF excerpt, or adapted into a quick-reference card for the toolbox?