Set this to 38400 or 115200 . (38,400 is the standard for classic ELM327 chips, while high-quality modified interfaces support 115,200). Data bits: 8 Parity: None Stop bits: 1 Flow control: None
Now that your Windows environment is perfectly configured, it is time to map those settings within Multiecuscan. Open the software on your PC.
If MultiECUScan still doesn't connect:
For newer Italian vehicles, the basic ELM327 cable alone may not be enough to access all systems. ELM327 v1.5 Latency too high - Multiecuscan multiecuscan elm327 port settings 2021
The console log will display OK for all commands and conclude with a message stating: "This interface is compatible with ELM 327 1.4! It can connect to all CAN modules."
To optimize the connection, adjust the properties of the assigned COM port in Windows: Port Settings : Match the bits per second to Advanced Settings Latency Timer (msec) : If using an FTDI-based cable, lower this value to
If you're using MultiECUScan with an Elm327 adapter, you'll need to configure the port settings to connect to your vehicle's ECU. Here are the steps to follow: Set this to 38400 or 115200
Before opening Multiecuscan, you must configure the virtual COM port assigned to your ELM327 interface by Windows. Locate Your Interface Plug the ELM327 USB interface into your computer.
To ensure I provide the most helpful advice for your specific vehicle setup, please let me know:
Under COM Port Number , change it to .
The 2021 model year introduced more sensitive CAN timing and FD protocols. Correct ELM327 port settings—specifically 1 ms latency , 115200 baud , and manual MS-CAN switching —are no longer optional but mandatory for reliable diagnostics with MultiECUScan.
: Plug your ELM327 interface into a USB port on your laptop.
Under > Advanced , change the "COM Port Number" to COM1 . Open the software on your PC
: For modules like Service Reset, Dashboard, or CAN Setup, Multiecuscan requires the Yellow Adapter to bridge the connection to the correct pins. Test Function : Always use the