If the battery is still in the vehicle: Connect RED to positive, then BLACK to a solid engine ground (not the negative battery post) to avoid sparking near the battery.
: Analog amperage meter, mechanical selection switches, and an integrated manual timer control Critical Safety Precautions
Disclaimer: This article is for informational purposes. Always refer to the original Autocraft AC-60CR manual for official instructions. Autocraft is a trademark of its respective owner.
If you need a more specific, in-depth , I can: Detail the exact LED light sequences for specific faults.
: Set the charger’s mechanical timer to the OFF position. Do not plug the AC power cord into the wall yet. autocraft battery charger ac-60cr manual
Check battery terminals for corrosion. Clean with a wire brush or baking soda/water if necessary.
Displays the current draw in amps. As the battery charges, the needle drops toward zero.
Plug the charger only into a properly grounded 120V AC outlet. Never alter the AC cord or plug.
Working around lead-acid batteries is dangerous. Batteries generate explosive gases during normal operation. If the battery is still in the vehicle:
Place the charger as far away from the battery as the DC cables permit. Never position the charger directly above or below the battery being charged. Step 2: Connect the Clamps (Negative Grounded Vehicle)
Working near lead-acid batteries is inherently dangerous due to explosive gases generated during normal operation. Adhere strictly to these safety protocols:
Once the engine starts, turn the charger off and unplug the AC power cord immediately. 6. Troubleshooting and Maintenance Potential Cause Poor jaw connection or dead outlet.
Clean your ground connection. Let the charger run on the 60A setting for 10–15 minutes to put a base charge into the battery before attempting another start. Autocraft is a trademark of its respective owner
Connect the charger clamps to the battery and chassis as detailed in the grounding instructions above. Ensure the clamps grip tightly for a secure electrical connection. Step 3: Plug in the Charger Plug the AC power cord into a grounded 120V outlet. Step 4: Select the Amperage and Start For maintaining a battery, select the setting. For standard charging, select the 10A or 40A setting.
Scrub off corrosion using a baking soda and water mixture with a wire brush. Clean terminals ensure optimal current flow and prevent arcing. Step-by-Step Operating Instructions Step 1: Position the Charger
A: Official manuals for this model are not widely available online, likely due to it being an older model. Potential sources for the manual include auction sites that may have included documentation with the sale, online manual databases like Manualslib.com, or by contacting the manufacturer, AutoCraft (a brand of Advance Auto Parts), directly.