Do not shorten the cable before identifying the cores. Use a digital multimeter to verify resistance values.
To get the most out of your unit, keep these tips from the Elmdene Technical Guide in mind:
The heart of this Grade 3 sounder is its internal battery backup.
Locate the silk-screened as FLASH DISABLE on the printed circuit board (PCB). elmdene 7422-sfg-g3f manual
When installing the contact, the fly-lead wires generally follow standard Elmdene color-coding schemas:
Connect the ENG terminal to a switched output on your panel to allow quiet maintenance without triggering the siren when opening the cover.
Requires a +12V signal to "hold off" (keep silent). Triggered by removing +12V. Do not shorten the cable before identifying the cores
Maintain a baseline installation gap of between the contact and magnet when the door is shut. Step 3: Fixing and Anti-Tamper Configuration
Ensure the mounting surface is flat and able to support the unit's weight.
Equipped with a Standby Battery (SAB) to ensure the alarm sounds even if the main power or control wires are cut. Elmdene International Installation & Wiring Guide According to the Rapier G Range Instruction Sheet Locate the silk-screened as FLASH DISABLE on the
The is a Grade 3, high-security external sounder (bell box). This guide covers the essential wiring and setup procedures for security installers. 1. Core Terminal Connections
1. Adjust door latches so the door does not rattle or drift outside the 10-15mm operational gap during wind or pressure changes. 5. Compliance and Standards